WAPDA NTS Test Questions with Answers
WAPDA NTS TEST 2016
Q & A (Yellow Question Book)
Note: The answers are underlined according to the key provided by NTS.
6) Motion of solid through fluid?
(a) Friction (b) Skin friction (c) Internal friction (d) External friction
7) Additive const. of tachometer?
(a) f + d (b) f + I (c) f / c (d) f – 1
10) Direct method of contouring?
(a) Fast (b) Economic (c) Accurate
12) Volume occupied by unit mass of fluid?
(a) Specific Wt. (b) Volume (c) Viscosity
13) Value of RN Reynolds number for laminar flow?
(a) 3500 (b) 6000 (c) 2500 (d) None of above
14) In pipe /conduit, flow is due to?
(a) Slope (b) Depth (c) Pressure (d) Density
17) Intensity of internal friction of body?
(a) Stress (b) Strain (c) Moment of inertia (d) Force
18) Column which fails due to buckling and crushing?
(a) Intermediate Column (b) Long Column (c) Short Column (d) Mid. Column
22) Schist’s are ____________ rocks.
(a) Igneous (b) Metamorphic (c) Sedimentary (d) Black
23) Joints parallel to bedding plane in red rocks.
(a) Dip (b) Oblique (c) Strike (d) Simple
24) Moment at walls and fixed joint of loaded member?
(a) Relative moment (b) Fixed end moment (c) Member Stiffness factor
(d) Simple
25) Plastic moment Mp =?
(a) 1.8 My (b) 2.5 (c) 6 (d) 7
28) Path reserved for pedestrians to cross __________________?
(a) Highway (b) Subway (c) Over head bridge (d) Runway
30) Showing end of speed limit ____________ which type of read sign?
(a) Informatory (b) Regulatory (c) Warning (d) Dangerous
31) Level crossing? Which type of sign.
(a) Informatory (b) Regulatory (c) Warning (d) Dangerous
32) Flashing yellow signal?
(a) Stopping (b) Starting (c) Warning
33) Stop with one or both ends rounded?
(a) Nosing (b) Bull nose (c) Slope (d) Sharp end
36) Horizontal dist. b/w two adjacent risers in stairs?
(a) Flight (b) Riser (c) Going or Run (d) Curve
42) Stress isobar line connecting all pts of equal stress?
(a) Seat of settlement (b) Pressure Bulb (c) Stress distance (d) Strain distance
44) In bearing Capacity Terzeghis assumptions in footing base is ?
(a) Rough (b) Smooth (c) Inclined (d) Curve
46) Test used for bearing capacity?
(a) SPT (b) Plate load Test (c) Sand replacement (d) None of above
51) Estimate should not exceed.
(a) 10-20% (b) 5-10% (c) 20-25% (d) 25-50%
52) Rate of Items + Labour input?
(a) Total Rate (b) Composite Rate (c) Fixed Rate (d) Input Rate
53) In estimates, percentage of cost of water and sundries is?
(a) 1-2 % (b) 3-4 % (c) 5-8 % (d) 9-13 %
60) Hydraulic mean depth?
(a) P.A (b) P/ (c) P/A (d) A/P
63) Crop period of rice?
(a) 90 days (b) 100 days (c) 120 days (d) 150 days
62) To overlook lighting of whole site area _______________ lighting pattern is used.
(a) Exterior (b) Interior (c) Medium (d) Upper
66) What are properties of slag cement?
(a) (b) (c) (d)
05) The force which acts only at contact?
(a) Body (b) Relative (c) Contact (d)
08) The difference between upper and lower staff reading is _________
(a) Horizontal distance (b) Vertical distance (c) Staff intercepts (d) Line intercept.
09) Leveling starts from
(a) Datum (b) Bench mark (c) CP
72) Ultrasonic pulse velocity test?
(a) Modulus of elasticity (b) Modulus of rupture (c) Strength (d) Dynamic modulus of elasticity
78) Submerged Wt. of body against Wt. of body in air is _____________.
(a) Same (b) More (c) Less
85) Special compaction techniques?
(a) Vib floatation (b) Blasting (c) Dynamic (d) _______
86) Joints parallel to strike of rock?
(a) Dip (b) Oblique (c) Strike
Thanks & Regards
Engr. Muhammad Umer Javaid (BZU Multan)
Project Manager
Extension of Multan Institute of Cardiology, Multan
WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions, WAPDA NTS Test Questions