Etabs & Safe Video Tutorials

ETABS & SAFE Video Tutorials in urdu by Engr. Ali Shan

Following are some of the video tutorials of Etabs for our valuable customers in Urdu and in English. ETABS is a programme for linear, nonlinear, static and dynamic analysis, and the design of building systems. From an analytical standpoint, multi storey buildings constitute a very special class of structures and therefore deserve special treatment. The concept of special programmes for building type structures was introduced over 30 years ago and resulted in the development of the TABS series of computer programmes.To download and Read More about Etabs here 

  1. Etabs & Safe Video tutorials in urdu Part 1
  2. Etabs & Safe Video tutorials in urdu Part 2
  3. Etabs & Safe Video tutorials in urdu Part 3
  4. Etabs & Safe Video tutorials in urdu Part 4
  5. Etabs & Safe Video tutorials in urdu Part 5
  6. Safe Single Footing Design

More Etabs Video Tutorials

Etabs & Safe Video Tutorials

  1. Etabs – 01 Introductory Tutorial
  2. Etabs – 02 Drawing Drafting Controls
  3. Etabs – 03 taggered Trusses
  4. Etabs – 04 Modeling Shear Walls with Openings
  5. Etabs – 05 Designing Shear Walls with openings
  6. Etabs – 06 Shear Wall Design Options
  7. Etabs – 07 Wall Meshing
  8. Etabs – 08 Steel Frame Optimization
  9. Etabs – 09 Linear Ramps
  10. Etabs – 10 Radial Ramps
  11. Etabs – 11 Concrete Frame Design
  12. Etabs – 12 Composite Floor Beams
  13. Etabs – 13 Section Designer
  14. Etabs – 14 Sequential Construction
  15. Etabs – 15 Panel Zone Deformations
  16. Etabs – 16 Auto Edge Constraints
  17. Etabs – 17 Section Cuts

To downloads Etabs software and other softwares. visit this link

54 Replies to “Etabs & Safe Video Tutorials”

  1. dear brother i am interested in learning about design software.my experience is in field but i want to go in design side.can you give me time ???

  2. today i got my membership it was aowsem site recommended to join this site its very help full and admin and all member this site excellent .thanks
    regards SYED FAHAD

  3. HOW to calculate the values of (f’c) (fy) (fy)v phi flexure phi shear phi torision values in beam cad software i am working in meter drawing my all units are in mm and m and cm so tell me in that criteria thanks kindly mail me if some of one you knows
    thanks regards
    SYED FAHAD

  4. Salam kindly upload some more tutorials brother to make this section powerful .these are only few videos.AGAIN requesting to you to uploadsome videos.thanks

  5. thats a good move to safe and etabs tutorial and also upload PEOKON VIDEOS..any way zberdast shearing your whole team working so hard..THANKS..

  6. I want to get membership, please give me the detailed procedure to do so.

    Thanks

  7. Dear Sir,
    Thank you so much for your efforts in providing video tutorials for engineering software. I have plan to become a member, so that I can download videos tutorials. Could you please guide me, how can I become a member and how much is the membership fees.

    Thanks,
    Naqeeb Ullah

  8. Dear sir if you can give an opportunity for internship as well then I will join after my graduation.. If you can please.. Sir